Push Pull Converter Pspice Student

Student

Power Converter Transformers Select flyback or flybuck ™ for up to 120 W, push-pull for up to 200 W, forward-mode for half-bridge, full-bridge, or active clamp up. The advantage of push-pull converters over flyback and forward converters is that push-pull converters can be scaled up to higher powers. Further, both of the MOSFETs are connected to the low-side (unlike a half-bridge converter, which has one MOSFET connected to the high-side). The push-pull topology does not require gate drivers for the MOSFETs. Over the years that this project has run there has been a wide range of converter designs implemented. Each year a few groups, generally the weaker groups, will perhaps only get as far as implementing a simple chopper circuit. While the more able groups of students have produced some very sophisticated designs utilising push-pull and Cuk. 2 reviews for Simplified Model of DC DC Buck Boost Converter sara – June 16, 2016 helloMy project is about buck boost converter 48v to 12v with P=3Kw and I=210A i tried to draw my buck boost in pspice but i have a problem i don’t get the right result i need your help pleas.

sch - 1010.02 kB - 07/28/2016 at 04:00

esquemágico.brd

board in eagle cadsoft,
it works!
it just wants review to drop out some jumps.
we do this, with silk screen method.
thats pretty good!

brd - 171.54 kB - 07/28/2016 at 04:00

IR2104.zip

IR2104 LTSpice Model
IR2104.sub is a spice model file, paste in '%LTSpice main dir%/lib/sub'.
IR2104.asy is a LTSpiceIV graphic compoenet model, paste in '%LTSpice main dir%/lib/sym'.

Zip Archive - 1.03 kB - 07/16/2016 at 18:24

DC-DC.asc

LTSpice Full DC-DC converter schematic
ps: need IR2104 model in LT lib to works fine

asc - 12.05 kB - 07/16/2016 at 18:19

anti curto V 2.b.asc

Alternative version for short-circuit protection (anti curto V 2.a), more components, but more powerfull

asc - 2.73 kB - 06/28/2016 at 12:54

anti curto V 2.a.asc

Second version of short-circuit protection

asc - 2.08 kB - 06/28/2016 at 12:49

VCO.asc

LTSpice Schematic of voltage controlled oscillator (V.C.O.) used to command IC ir2111 to 'attack' the MOSFet

asc - 2.45 kB - 06/28/2016 at 02:28

OptoIsolation4n25.asc

LTSpice Schematic of the isolation circuit of feedback voltage signal of output

asc - 903.00 bytes - 06/28/2016 at 02:28

short-circuit protection.asc

LTSpice Schematic of basic short-circuit protection and overload protection, using a low resistance value to transduce the electrical current value

asc - 1.64 kB - 06/28/2016 at 02:28

HomeApplied Mechanics and MaterialsApplied Mechanics and Materials Vols. 336-338Design and Analysis of Push-Pull Switching Power...

Abstract:

Aiming at the problem of switching power supply stable output, a push-pull switching power supply was designed. the switching frequency is 100kHZ and the output voltage is 5V. System model of the push-pull switching power supply is established on PSpice, and research on the output performance of the push-pull switching power supply. By the parameter sweep analysis of load, the push-pull switching power supply can stabilize output in full load and light load conditions, and load regulation rate comply with the design requirements.

Pspice

Push Pull Converter Pspice Student

Pull
Pspice Simulation, Push-Pull, Switching Power Supply

[1] Hua-zhong Xu, Chang-zhe Chen, SMPS Noise Analysis and Treatment Method, in: Journal of WUT(information and management engineering), Issue 6, Volume 32(2010), pp.900-903.

Push Pull Converter Pspice Student Download

[2] Z. Lukic, S.M. Ahasanuzzaman, Z. Zhao, A. Prodic, Self-Tuning Sensorless Digital Current-Mode Controller with Accurate Current Sharing for Multi-Phase DC-DC Converters, IEEE Applied Power Electronics Conference (APEC), 2009, pp.264-268.

Pull

Push Pull Converter Pspice Students

DOI: 10.1109/apec.2009.4802666

[3] Zhimin Zhou, jihai Zhou, Aihua Ji, switching power supply technology, Posts & Telecom Press, (2007).

Converter

[4] J.A.A. Qahouq, L. Huang, D. Huard, Efficiency-Based Auto-Tuning of Current Sensing and Sharing Loops in Multiphase Converters, IEEE Transactions on Power Electronics, vol. 23, no. 3, March 2008, pp.1009-1013.

Push Pull Converter Pspice Student Version

DOI: 10.1109/tpel.2008.917808

[5] Ya-lan Xiong, Discussion on Efficiency and Noise of Switch Power, in: Fire control radar technology, Issue 6, Volume 34(2005), pp.59-62.